RCONAG6 and Multiple IPs

[Guest_imported]

I am trying to load RCONAG6 on a NW5 server that has two IPs bound to one adapter (alternatively, i've tried with two adapters and one IP each)....
There's a 10. NAT address, and a 66. public static address. I am wanting the RCONAG6 to bind to the 66. address for remote management purposes, but it always binds to 10. I cannot find anything to specify which IP to bind with, all I can gather is that RCONAG6 defaults to the smaller number?

Any help would be greatly appreciated!

 

[TheLad]

The only way I can think of doing it is to load the network card drivers and bindings for your public card, load RCONAG6, then load your private network card and drivers.

If you use INETCFG and load INITSYS.NCF in the AUTOEXEC.NCF, you could manually amend the file SYS:ETC\NETINFO.CFG so this happens, however amending that file does cause other issues.... -----------------------------------------------------
"It's true, its damn true!"
-----------------------------------------------------