Rapid Connect

[Dphone]

Is there a way to change the "Rapid Connect-Data" default setting from Data to Telnet? So every time you start Promcomm you don't have to use the pull down meun to select Telnet.

 

[knob]

If you shut down Procomm while the connection is set to telnet, it should come back up in telnet mode and the Rapid Connect will default to telnet connections as well. You might also check that you are not opening Procomm in data terminal mode.

http://www.aspectscripting.com

 

[Dphone]

I am rlogin through MMS Telnet. How do make it open in the telnet mode. I shut it down in the MMS Telnet mode, But it always opens the the Data mode.

 

[knob]

I'm not familiar with MMS telnet, is that a proxy or a link that can be clicked in a browser to launch the telnet connection via Procomm?

http://www.aspectscripting.com