RAD on SX200 Analog

[idahomitel]

Anyone know how to interface an EZ-announce RAD to an analog sx-200?

 

[pandabear1]

what will be the function of the RAD?

 

[idahomitel]

To announce the wake-up call.

 

[pandabear1]

the RAD must be connected to an analogue port and then programed into a hunt group
then the console must program the following (this is the part I am not a 100% sure of as it has been a lot of years since I did this:
dial *230
dial RAD equipment number
press release

this part you do need to define the recording group and AWU:
dial *234 from console
dial the recording group (hunt group) access code
press release
Also the length of the message on the recording must be specified:
dial *242 then the recording group access code recording duration in a 2 digit seconds then press release.

If need be I can see if I can find a console guide, let me know.
Good luck

 

[idahomitel]

Thanks for your help. I do have a console guide, and found those commands. I just have never seen or done this before. It doesn't look too tough! Thanks again, pandabear1.

 

[idahomitel]

The only thing I got wrong was that you should not program the port with an extension number! After I took out the extension number, everything programmed up perfectly.