R7 Loudspeaker 2

[johnhoff]

Replaced a ACS R1 that was using a Page Pac 6. I have 1 R7 Processor, and 2 308 expansion mods. Using 7 active lines now. The equipment was put in for expansion. Cannot get loudspeaker to work. Used #617 to select. Should I be using the page pac, or not? Should I use co line 8 or co line 11

Thanks in advance

 

[ttech]

If the Pace Pac reqiures Contact closure to then on you should be using port 5. Then you would assign lines 1-4 and 6-9 to the phones.

 

[johnhoff]

Did u mean 6-8 ? What do I do with #617 ?

 

[TouchToneTommy]

What ttech said - connect the page pac with a 4-conductor line cord to CO-5, assign CO-5 as the page port in #617, connect your outside lines to CO-1 through 4, and 6-8 (for 7 line appearances), assign them to the phones in that order, but label them lines 1 through 7. Remember when programming things like call dist group, VMS answer rings, etc., that "line 5" on the phones is CO-6, and so on.