Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Chris Miller on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

R1T1 to 6.1

Status
Not open for further replies.

geauxnads

Vendor
Jan 7, 2004
59
US
Will I lose my programming on a MICS R1T1 when I upgrade to a 6.1 ? What are the procedures ?
 
You will lose your programmng. Do a print configuration report from a Fast Rad using N* manager, (or take config out by hand) then upgrade and reprogram using the C1UR1 Handbomb technique.
Ugly but true.

Cheers
PhM

 
if you do a 2 step from 1 to 4 to 6.1 you would keep most of your programming but you need upgrade tool and would need to verifiy alot of proggramming to insure it carried over correctly

Pat Guido
NEXTIRAONE
Pat.guido@nextiraone.com

Formerly Nextira, formerly Williams Communications, formerly Wiltel, formerly Nortel networks, formerly Northern Telecom, formerly, Nynex meridian systems formerly Northern Telecom.

 
Like Pat said. Borrow a copy of Rls 4 and an upgrade tool. Power down, take out R1T1 and put in new software NVRAM. Put in the upgrade tool. Wait for "insert MICS" message on phone. Power down and replace upgrade tool with Rls 4. Power up and wait for it to finish. Power down and put in 6.1 power up and wait for finish.

You will need to re-do/check the target lines for sure. Everything else "should" be fine.

Be smart and do like they say. Get a paper copy of all programming, just in case!
 
just double checked and installation docs say yes you can

Pat Guido
NEXTIRAONE
Pat.guido@nextiraone.com

Formerly Nextira, formerly Williams Communications, formerly Wiltel, formerly Nortel networks, formerly Northern Telecom, formerly, Nynex meridian systems formerly Northern Telecom.

 
WHERE DO WE GET THE UPGRADE TOOL AS i HAVE A 4.0 SOFTWARE
 
if you have a 2 part software cartridge you wont need the upgrade tool only from r1t1 thru 3.0 do you need upgrade tool and if you need it you need to contact a dealer

Pat Guido
NEXTIRAONE
Pat.guido@nextiraone.com

Formerly Nextira, formerly Williams Communications, formerly Wiltel, formerly Nortel networks, formerly Northern Telecom, formerly, Nynex meridian systems formerly Northern Telecom.

 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top