R1 number in ISDN qsig

[sharif588]

sharif588 (TechnicalUser)(OP)4 Sep 16 23:25
i have a qsig line with cisco cube router and Aastra (new mitel) MXone BC13 , and call flow ISDN pri> cisco cube router > Q-sig > MXone.
so when i dial R1 nubmer and routed via qsig to Mxone it never work
but it always working with direct ISDN connection to MX one.

here the route config qsig:
<ROCAP:ROU=71;
ROUTE CATEGORY DATA
ROU SEL TRM SERV NODG DIST DISL TRAF SIG BCAP
71 0110000001000010 3 2110030000 0 30 128 03151515 110100000031 001100

<ROdAP:ROU=71;
ROUTE DATA
ROU TYPE VARC VARI VARO FILTER
71 SL60 H'00001310 H'00000000 H'06300000 NO


and here the direct isdn config MXOne

<ROCAP:ROU=61;
ROUTE CATEGORY DATA
ROU SEL TRM SERV NODG DIST DISL TRAF SIG BCAP
61 5110000000000010 3 3100000001 0 30 128 00151502 111100000030 101100

END

<ROdAP:ROU=61;
ROUTE DATA
ROU TYPE VARC VARI VARO FILTER
61 SL60 H'00101020 H'14400003 H'00410000 NO

can any one please help

 

[ceejay55]

It is supported over the following signaling systems and protocols:
• ISDN trunk
• Digital Private Network Signaling System (DPNSS)
• Digital Access Subscriber System (DASS)
• Multi-Frequency Compelled R2 (R2 MFC)
• H.323 trunk
• Signaling System 7 (SS7)
• SIP trunk (see separate Operation Directions MOBILE AND REMOTE EXTENSION
OVER SIP)

 

[fcpli]

What do you mean by R1 number? Remote extension or something else?

 

[sharif588]

R1 is the access number for a mobile extension or a fixed extension when A- number is received in PABX,

 

[sharif588]

it is saying in ALex : ISDN/QSIG support
It is necessary to have a connection to the PSTN or PLMN from the PABX.

The signalling schemes supported are:
• DASS/DPNSS using a TLU76/2 board.
• DP/DTMF/R2-MFC using a TLU76/3 board.
• ISDN/QSIG using a TLU76/1 board or a TLU77/1 board or a TLU79 board.
• H.323 using a ELU32 board or a IPLU board

 

[fcpli]

What happens if you change SERV D10 to "1"?