We setup a 5 carrier a year ago running R3.0 with a R1 Message Module. I am computer based not phone based. At the time we used RS232 to go in and set an ip address for the local net. In the mean time installed a new Dell server and reassigned fixed and DHCP ip addresses. Now a year plus later need to get back and setup the Messenger module to assign a correct ip address and have forgotten password. We also have a 2 port card installed in R1 module. The goal is to listen to voicemail as email attachments. How do we default the module back to original mode?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations derfloh on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
R1 Message Module / Password
- Thread starter ScanMan68
- Start date
TouchToneTommy
Vendor
Use the same numeric password that you use to access the System Administrator's mailbox.
- Status
Similar threads
- Locked
- Question
- Locked
- Question
- Locked
- Question
- Locked
- Question