R emote Paging Won't Work In 4.1 1

[JN55]

I’m setting up remote paging. I programmed in lines, Ans mode: auto, Ans with DISA: Y .
I have one client with MICS 3.0 and it works great. I tried to set it up on MICS 4.1 and it Won’t work, no dial tone. I went to another client that has MICS 4.1 and the same results. Does anyone know if a patches is out for 4.1 or some kind of fix.

Thanks for any information.

 

[jerryreeve]

In order for DISA to work there has to be a tone generator and DTMF receiver in the system (a COMBO cartridge in slot 2). Do you have this on both the systems? JerryReeve
Communications Systems Int'l
com-sys.com

 

[Multitech]

Thanks JerryReeve, that was the answer. I put a Combo cartridge in slot 2 and it worked. Do you know if the DISA could work with a Services Cartridge in slot 1 only, or does it only work with a Combo Cartridge?
Thanks for your help.

 

[jerryreeve]

Yes, as far as i can tell you can use a services cartridge to provide the tone generatore/dtmf reeivers for disa in slot one (a services cartridge can only go in slot one) or one of the combo cartridges. JerryReeve
Communications Systems Int'l
com-sys.com