Hi all,
Somebody explains me what do "switch" and "stack" interfaces displayed in port configuration menu really mean. Both of them operate in 10Mbps/Half mode by default, what if i change these values? Never tried though. Thanks.
The 'switch' interface can be used to change all of the ports on a switch to a given setting, the value displayed doesn't really 'do' anything unless you highlight it and press enter to configure the whole switch. I don't stack many switches but I assume the 'stack' interface you mention will do the same thing for all of the interfaces on a whole stack.
In addition to speed/duplex you'll notice there are probably options to globally enable/disable ports and set linkUp/Down traps.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.