"Routing" within an X450e?

[BobMCT]

We have a series of X450's with multiple VLANs defined. Works fine... except:

We need to cross subnets from one subnet to another and for some reason we cannot get this to happen.

Here are some example IP's

source subnet is 10.10.199.0 through a VPN Tunnel and the remote subnet is 10.10.100.0. The server this remote point needs to reach is in the subnet 10.10.100.0 as well and there is NO ping happening.

However, from the switch, we can ping the 10.10.199.0 subnet and the 10.10.100.0 server. We just cannot PASS signal through the switch.

Any ideas as to what we need to look at to accomplish this relatively minor feat?

TIA - Bob

 

[dearingkr]

You'll need to enable ipforwarding and set a default gateway.

enable ipforward vlan a
enable ipforward vlan b

conf iproute add default x.x.x.x


MCSE CCNA CCDA