Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

"MAP FAILURE"

Status
Not open for further replies.

venkatpavan

Programmer
Feb 18, 2006
42
SG
Hi,

I'm getting following error when I'm trying to run the file(Huge file of 3GB).

"MAP FAILED Not enough memory to execute map"

I tried options like trace off,Page size/Setup chages and changing wworkspace from memory to file.

Could someone have better ideas on this???

we are using WTX 8.2
 
I tried burst mode and it is reading and processing the file faster with out any error but the output it is writing is only for last burst,Is there any setting that I'm missing.

Thanks,
 
you can try one of these options

set output to append

redefine your type tree
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top