Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations IamaSherpa on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
"change system programming port to
- Thread starter billings
- Start date
Is the data you are restoring from a different processor or release. You can only restore from same release programming from a flash memory card. Your only option if it is a different release is to restore to a processor with same release software as the memory card, use Winspm to save, then convert, then restore to new processor. Hope this helps.
This message means that what ever extension you are using to program the system is not in the first port on the first mlx card, you need to look at the original program port and before doing a restore you have to change the program port to that port. before restoring trace the jack back or better yet go into maintanance-ports-station-status and see what slot and port your program extension is using then when you put the new proc in go into prgramming and change the new board to that port before restore.
- Status
Similar threads
- Locked
- Question
- Locked
- Question
- Locked
- Question
