morgansdad
Technical User
I am going to rebuild/move a BCM400 3.7 for a customer at another location. Can I re-run the quick start wizard again and start programming from scratch? or should it be run only once, like it says?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Quick Start
- Thread starter morgansdad
- Start date
- Status
Johnthephoneguy
Technical User
If they are just moving why would you want to start from scratch? Unless you are getting paid by the hour its a waste of time, just make sure the wiring is labelled and make everyones extensions the way they were.
You can verify the port numbers of the phones and cross-connect accordingly. Have the customer put tags on the phones as to whom they belong and where they are going. We usually make a cut sheet before we move the system. You should not have to reprogram.
SHK Certified (School of Hard Knocks)
SHK Certified (School of Hard Knocks)
A great feature to use when you move a BCM is set relocation. Turn it on before you disconnect any phones. Move the system. Then you can cross-connect any digital port to any station cable. When you plug in the appropriate extension, it will be the same as it was before the move.
- Status
Similar threads
- Locked
- Question
