I have to manually initialize our Opt. 81C so that some buffer changes in the CFN take affect. I know this has to be performed on the active core. Do I need to place the ACD in Maint mode? I am under the impression that you only do that when the core is in standby and you need to perform maintenance. If you can direct me to the appropriate manual concerning this, I would be most appreciative.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Quick Manual Init Question
- Thread starter Watsonj
- Start date
BangkokMike
Technical User
If you have the books look under LD 135 and 137, strongly suggest you also do a LD 43 data dump before you INI your switch.
- Status