A few questions on adding a PRI/DTM to a 3.7 BCM 400.
1.Does the DTM have to go in the base cabinet-(found conflicting info in the doc.)
Can it go in the expansion?
2.If it does have to go in the base the 400 has a 4th slot for what looks like a media bay mod.The doc does say only three slots are availiable in the base.What is the 4th for?
3.If you have to move a module-(CTM) out of the base in order to install the DTM-can you remove the module-(CTM) and simply plug it into the expansion and not have to change the dip switch settings?If the dip switches determine the DS30/BUS does it matter where it plugs in?
4.Anything else you can think of?
Thank You!!!
1.Does the DTM have to go in the base cabinet-(found conflicting info in the doc.)
Can it go in the expansion?
2.If it does have to go in the base the 400 has a 4th slot for what looks like a media bay mod.The doc does say only three slots are availiable in the base.What is the 4th for?
3.If you have to move a module-(CTM) out of the base in order to install the DTM-can you remove the module-(CTM) and simply plug it into the expansion and not have to change the dip switch settings?If the dip switches determine the DS30/BUS does it matter where it plugs in?
4.Anything else you can think of?
Thank You!!!