In all documents the leading and kerning up/down left/right arrows are locked. I can lead by doing each line under leading but have apparently locked out the command on my measurements palette. I must have turned something off and could use your suggestions. Other measurement tools work fine. Suggestion??? Thanks, B
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Chris Miller on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Quarkxpress 8 leading and kerning recently locked on measurements
- Thread starter sparkee1
- Start date
..not sure it's possible to lock the measurement options. I would try deleting your quark preference files and restart quark.
andrew
============
============
andrew
============
============
- Status
Similar threads
- Locked
- Question