Qsig Siemens 3750 integration

[Mitelpassion]

Hi has anyone tried QSIG integration between a 3300 and a Siemens 3750?

software version on Siemens is release 4 and Mitel release 8.
have tried this with local Siemens support but not sucessful.

if anyone has done it do you have a whitepaper for it perhaps?

 

[Bas1234]

Wich Qsig version does the Mitel support now a days? Been out of the Mitels for 4 years.

You should try the S0: ECMA-Qsig Master direkt CR=2 CHI=S2 on the Siemens.

Is it directly connected, you'll need a crossover cable then.

___________________________________________
It works! Now if only I could remember what I did...
___________________________________________

 

[Bas1234]

Another thing for the Siemens, you'll need to use "Trk Grp16" for VOIP.
Untick all routing flags, put routing typ on CO.
And use LCR internal telephone number must be add as 1-X-X mostly MCL single stage.

___________________________________________
It works! Now if only I could remember what I did...
___________________________________________

 

[Bas1234]

What version of the mitel 8 UR4?

Feature Enchancements in Release 8.0 UR4 (8.0.10.7_1)

• Inward Dialing Configuration, which originally supports on Euro-ISDN protocol, is expanded to support on QSIG trunk using embedded module only. NSU does not support Inward Dialing Configuration on Q.SIG protocol.

___________________________________________
It works! Now if only I could remember what I did...
___________________________________________

 

[Mitelpassion]

thanks for the replies.

8.0 UR 4 is 8.0.10.7_1

you say Trk Grp 16 VOIP, eventhough it's a QSIG link?
What's the significance?

thanks again

 

[Bas1234]

Yes, you'll need to use 16. Don't no the exact reason why?!
But it's somewhere in the manual. It's also needed if you program Cornet.

___________________________________________
It works! Now if only I could remember what I did...
___________________________________________

 

[Mitelpassion]

thanks,

have you personally tried an integration?
have been strugelling for months to get this working