Qsig - MX-1 TSW

[Monrovia]

Hi

new question!

My system : MX-ONE TSW SP7 : VERSION=CXP1010101/4/TSWSP07/R7G

I would like to install Dimatra IP Compact R2.0 using E1 Qsig with MX-One.

I configured it like this:

[tt]<RODDPEST=088;
EXTERNAL DESTINATION ROUTE DATA
DEST DRN ROU CHO CUST ADC TRC SRT NUMACK PRE
088 28 260600000000025000000000000 0 4 0

END

<ROCAP:ROU=28;
ROUTE CATEGORY DATA
ROU SEL TRM SERV NODG DIST DISL TRAF SIG BCAP
28 7130000000000010 5 3100000001 0 30 128 00040415 311110000031 111111

END

<RODAP:ROU=28;
ROUTE DATA
ROU TYPE VARC VARI VARO FILTER
28 SL60 H'00000350 H'45460000 H'04400003 NO [/tt]

I am connecting through to dimetra. I am getting incoming calls from the dimetra. but, i cannot make outgoing calls.
Could you please assist me to make it working?

Thanks & Regards

Monro

 

[fcpli]

These parameter settings seem to be a little bit confusing. I got the Dimetra working with following (check also your TRAF ic CDCAT): SERV =311xxxxxx,
VARC=00000300 (the Dimetra is not an MX-One!)
VARI=15480000
VARO=06400000 (or 06300000)
Grab a trace from SL60, and check that the setup etc. is OK (if not working with these settings). Also, the Dimetra techs have to use corresponding settings in their eqpmt.
Note that the network services are not working properly with the Dimetra, so you can try to skip them.....

 

[Monrovia]

Thanks FCPLI,

let me try with this settings.

Also I will contact Dimetra techs.


Best Regards

Monro

 

[lindelott]

for FCPLI

VARC=00000300 (the Dimetra is not an MX-One!)

what do you mean?
denny