Qsig MD110(BC9)-Alcatel

[DEIVIDOS]

Hi,
We had MD110 BC9 connected through Q-sig with Alcatel OXE (Omnipcx enterprise) system
I can make *22#dest ext# successfully, but not *21*dest ext# And FME TO the MD works too from the ohter pabx.

The parameters of QSIG are:

<ROCAP:ROU=20;
ROUTE CATEGORY DATA
ROU SEL TRM SERV NODG DIST DISL TRAF SIG BCAP
20 011010010000 5 3110000003 0 30 128 03151515 511110000031 111111

END

<RODAP:ROU=20;
ROUTE DATA
ROU TYPE VARC VARI VARO FILTER
20 SL60 H'00000310 H'15400000 H'06000000 NO

<RODDPEST=474;
EXTERNAL DESTINATION ROUTE DATA
DEST DRN ROU CHO CUST ADC TRC SRT NUMACK PRE
474 20 1606100000000250 0 1 0

Also I try with the ADC 1505100000000250 in the dest 474


Any advice,
Thanks in advance

 

[pimpsta]

*21* is procedure only for internal diversion, *22* - is for external FOLLOW -ME diversion! Also check CDIV parameter which allows it!

 

[rfpup]

1.external follow me:
activation *22#external dest#
deactivation #22#

2. internal follow me:
activation *21*internal extension#
deactivation #21#

 

[DEIVIDOS]

Hi,
sorry i can`t do it *21*Alcatelextension# trough Qsig conection.
any ideas??
Thanks

 

[rfpup]

I think that *21* procedure function only inside one Ericsson PBX(someone may correct me if I am wrong)
I can not do *21* procedure with two Ericsson PBX-es MD110 via IP networking and QSIG networking.
I think you have to try *22#Alcatel extension#
and #22# to deactivate

 

[whosrdaddy]

Guys,

*21* is also allowed on QSIG connections and that's what DEIVIDOS has towards his Alcatel PBX.

D5 of the ADC value is set to 1 which is only allowed for calls terminating in another MD110 (proprietary E/// protocol). This parameter should be set to 0 (so 1606000000000250 )

Cheers,
Daddy

-----------------------------------------------------
What You See Is What You Get
Never underestimate tha powah of tha google!

 

[COUNTOLIVER]

You have to use ISO-QSIG (not UUI), but BC9 is really poor about ISO-QSIG.

Basic Call, Calling/Connected Line Identification, Advice Of Charge and Name Identification are supported according to ECMA-QSIG and ISO-QSIG standards