I'm trying to get an Explicit Call Transfer to work but it seems my settings in the MD110 are wrong.
Does anyone have such solution and know what these settings are ?
Well, the function I need is the following.
I call to a voice response system, connected to the MD110, say on channel 1.
Then the voice system puts the caller on hold and dials another extension.
Through a command on the Voice systems I can connect the two calls with each other and channel 1 of the voice system is free again.
Another term is transfer with route optimization .
Look at parnum 223 ,and having the route to vm as iso q-sig .
Note !Standard supplementary service for transfer &
path replacement.
I have this option Path replacement working to my automated operator/Voicemail (Cycos MRS) using ECMA Qsig settings below. You may also want to cahnge the default path replacement/Optimaization timing by default thsi ASPAC is set at ten seconds.
<ROCAP:ROU=100;
ROUTE CATEGORY DATA
ROU SEL TRM SERV NODG DIST DISL TRAF SIG BCAP
100 711002500000001 5 3110000011 0 30 128 01151515 111111000031 001100
END
<RODAP:ROU=100;
ROUTE DATA
ROU TYPE VARC VARI VARO FILTER
100 SL60 H'00000310 H'15460002 H'06300000 NO
we tried the Config you wrote in conjunction with an "Eicon Diva Server 4BRI 2.0" ISDN-Card, but the MD110 did not understand the facilities the Eicon card sends (i.e. CallTransferComplete). With ISO QSIG the CallTransfer and Pathreplacement worked fine (except for the 3,3 Seconds until the parties are connected and can hear eachother).
What kind of ISDN-Card do you use with Cycos MRS?
As the traces show the MD110 only recognises properity UUI-elements for the supplementary QSIG-Features like CallTransfer or Pathreplacement but not the facilities the Eicon-card sends. Basic-call works properly. The Ericsson-supporter sayed maybe the feature is not present in the OS of MD110 for the german market. In wich country is your MD110 installed? He sayed "...ask him to get a PCLop of SLP60 and TLP60, then we can see wich patches had been installed".
Could you do me this favour, please?
I have MD110s installed in four different countries all using this feature, all with the standard AS. They are installed in Pristina Kosovo , Abidjan Côte d'ivoire, Freetown Sierra Leonne and Kinshasa DR Congo. Do you have the latest Eicon Drivers? I am not familar with the German AS for MD but I would be suprised if this feature was not available. I am running BC11 SP13 at these sites, I know there when some problems with early revs of BC11 (SP6 I think). From My earlier discussion with Cycos about this feature they told me Eicon did initial testing with the MD110 when introducing this feature on the Eicon boards. I don't have access to any sites at the moment to get you a PCLOP, I will be on-site on Tuesday and I will post the PCLOP then.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.