Qsig between Pansonic and MD110

[gerard2011]

Hi

Does anyone have experience in connecting an Panasonic KXTDE or similat to an Md110 bc11 or bc12 system by way of ISDN Qsig.

I would like to know if anyone has setup something similar.
I would be familiar with the Panasonic PBX's but not the MD110

Regards
Ger

 

[cwc3]

if its point to point that is pri cards in each system it should work you will need
a RTC in the td and use the other system as a slave and then you woill have tie truncks between the 2 but the TDE would be a better choice the td does not have great tie routing tables

http://www.thetelephonemanonline.com

 

[gerard2011]

Thanks cwc3
I would be familiar with the setup of Qsig on the Panasonic but I wouldn't be on the MD110.
Some of the settings required would be
On PRI 30 Ch card
CRC4 on or Off
QSIG Master or Slave

On Basic Rate
Network either Point to Point or Point to MultiPoint

I would like to know what these settings are on the Md110

Tks
Ger

 

[cwc3]

tde/tda/ncp in the states does not support bri or pri 30 ! I have never touched a md1101 or any nortel for that matter in 30 + years in the biz except for hardware macs!ask the guy who maintains it to provision it for you !

http://www.thetelephonemanonline.com