QSIG between OPT11 and Cisco 3825

[bernece]

Hi all,
I have created a QSIG trunk between a remote option 11 and the Cisco 3825 at the same location. I have been able to get the 2 systems to see each other, but am unsuccesful in completing a call accross the trunk. I get a fast busy when I try to make a call from my ip phone. I see the call hit the router but never see it hit the option 11. Any usefull help will be greatly appriciated.

 

[johnpoole]

how are you sending calls between the two? dsc acod ? what does ld 60/96 say about that link?

is the d estb and all channels idle?

john poole
bellsouth business
columbia,sc

 

[telebub]

And post your d-channel/route/trunk programming for the QSIG setup.

 

[Reusser]

check this link for Rls Notes on config for both Cisco and Nortel

http://docs.google.com/viewer?a=v&q...Ukez39&sig=AHIEtbSnP3gE1WHl5XTU3oXoN3pEJTTWzw

 

[bernece]

Thank you for your responses. I did find the problem. It was a binding statement on the router that was causing layer 3 not to communicate between the router and the option 11.