QSIG between IPO500 and Panasonic NS700

[raist3001]

Searched the forums but could not find specific info.

Looking to link an IPO500 and NS700.

My boss tells me I can do so with QSIG?

Searching the internet comes up with a lot of info but not NS700 specific.

Anyone able to point me in the right direction?

Thanks,

 

[Okkie26]

Which part are you looking help for?

IPO or Panasonic?

Any experience in setting up one of the systems?

 

[raist3001]

Looking for help on both. I have experience in setting up Avaya and NS700.

 

[Okkie26]

Then what info do you need?

 

[raist3001]

Sorry when you asked if I had experience setting up one of the systems, I do in regards to SIP trunking, and SCN.


Not sure How the QSIG is set up on either systems.

 

[Okkie26]

For qsig you need Voice networking license in the IPO.

Then, qsig is only supported in PRI trunks.

But you can connect via ISDN-2, but then not qsig.

Make sure the numberplans on both sites are unique. And you will need to setup routes to and from both systems to each other.

It's not that hard. But it needs some 'trial and error'

 

[intrigrant]

Use a H.323 trunk between the 2.
Still need a voice networking license on IPO but it will work, we have a IP500v2 9.1 connected within a network of several NS700 systems.
Don't ask about the NS700, I have nearly no knowledge of them but on IPO it is quite simple.