QSIG BC12-BC12

[Runis]

Hi,
I am trying to set up a Q-SIG between two MD110 BC12 SP5, but internal follow me (*21*6XXX#) does not work through the Q-SIG (it does internally). I can make calls and call back works fine. My route is:

SIDE A:

<RODAP:ROU=90;
ROUTE DATA
ROU TYPE VARC VARI VARO FILTER
90 SL60 H'00000310 H'15400000 H'06300000 NO

END

<ROCAP:ROU=90;
ROUTE CATEGORY DATA
ROU SEL TRM SERV NODG DIST DISL TRAF SIG BCAP
90 5110000000000010 4 3010030000 0 30 128 03151515 111110000031 111111

END

<RODDPEST=6;
EXTERNAL DESTINATION ROUTE DATA
DEST DRN ROU CHO CUST ADC TRC SRT NUMACK PRE
6 90 1606100000000250006000000 0 1
0

SIDE B:

<RODAP:ROU=90;
ROUTE DATA
ROU TYPE VARC VARI VARO FILTER
90 SL60 H'00000310 H'15400000 H'06000000 NO

END

<ROCAP:ROU=90;
ROUTE CATEGORY DATA
ROU SEL TRM SERV NODG DIST DISL TRAF SIG BCAP
90 5110000000000010 4 3010030000 0 30 128 03151515 111110000031 111111

END

<RODDPEST=6;
EXTERNAL DESTINATION ROUTE DATA
DEST DRN ROU CHO CUST ADC TRC SRT NUMACK PRE
5 90 1606100000000250006000000 0 1 0

Hope you might help, thanks!!!!!!!!!!

 

[lancbomb]

check the trunk to trunk allow

do a catagory print for the route and extensions
then do a TCMAP:CON=ALL

 

[whosrdaddy]

officially, bc12 supports only ISO qsig, so vari must be 15440000 on both sides. you must also set aspac 223 to 7 to have all facilities.

cheers

--------------------------------------
What You See Is What You Get

 

[Runis]

Thanks whosrdaddy,

I tried with VARI 15440000 and works ok!!!!!!!!!!!!

Thanks for your help,

Runis.