Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Qsig alerting question

Status
Not open for further replies.

noidatech

Technical User
May 15, 2006
99
US
im not able to see far end PBX extension number when rining, though it sends name ( probably because its configured in DN configuration as alerting name)

is this alert number featurer actually supported with Q-sig in ccm 5.1?

cant see any parameter on Gw configuration , i heard its controlled using route pattern...

any ideas ??
 
do you see the calling number getting passed when you "debug isdn q931" on the voice gateway?

If so it is Q-sig mismatch between the two PBX's you are trying to integrate ( i'm making a huge assumption here that you are integrating two PBX's).


 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top