Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Westi on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

QOS and BGP

Status
Not open for further replies.

jimfixit

MIS
Aug 5, 2003
116
US
Just got done reading about nested QOS maps and one blurb I read indicated one should be careful not to define a catch all "IP Any Any" ACL for the default class. They sited that the reason was you would then exclude all your routing protocol traffic like BGP and EIGRP, etc.

They suggested if you must do that becasue your traffic is too varried to ACL everything, at least ACL the BGP and other routing protocols. What no one said though is, what class should you assign that too?

The config at this site does exactly that...sets up three ACLs one for voip/VTC as EF; one for special applications as AF41 and all other (match IP any any) as AF31. There's a 'default class' but it gets best effort. Looking at the ACL's that's where the BGP stuff would fall. Maybe that, and the fact that the bandwidth left over for the default class is like 1% of a 6 MB link explains why BGP is so slow to converge for these folks.

Anyway, the question is, suppose I set up a class for BGP...what class would I give it (not EF surely but maybe some AF level?) How much BW might one small 6-site MPLS network need? I'm about to just toss it in there with the lesser applications...af31 in this case.
 
i would put it in with the AF31 class. either that or remove the any/any ACE for default and make sure that you've got enough reserved bandwidth on the interface to support proper BGP comms. did they change the max-reserved-bandwidth on the interface from the default??

I hate all Uppercase... I don't want my groups to seem angry at me all the time! =)
- ColdFlame (vbscript forum)
 
not sure that it matters,

the router is working BGP in the control plane
normal traffic is routed in the data plane,

unless there is high cpu on the router, that might affect the management traffic (BGP) but that's where CoPP comes in.

whats the cpu utilization on the router ?

 
control plane/data plane doesn't matter. they both will use the same egress queues on the interface which is why you need to make sure there is enough bandwidth available to support proper communication.

I hate all Uppercase... I don't want my groups to seem angry at me all the time! =)
- ColdFlame (vbscript forum)
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top