Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations IamaSherpa on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

PTIME

Status
Not open for further replies.

OKACHA

IS-IT--Management
Sep 22, 2017
43
DZ
HELLO
CAN SOME ONE EXPLAIN THE MEANING OF THE PARAMETER P1 TO P14, L1 TO L7, S1 TO S14

BEST REGARDS
1_c8flas.jpg
 
These are device dependent. I've never messed with these settings, but I can read a book! :D
From this manual: A31003-H3160-S101-7-7620, 05/2014, HiPath 4000 V6, AMO-Beschreibungen, Service Documentation

There are 3 different TMANI tables. From this table: (119): DB_AM_DEV_TMANI_HKZ: TMANI HKZ

pic1_krof4a.jpg

pic2_arzbvc.jpg


Not totally helpful, but that's from the AMO guide! I'd suggest digging through that to get a better understanding of what's going on.

LoPath
Maintain HiPath 4000 V5 & V6, OpenScape Xpert V4 & V6, OpenScape Xpressions V7, OpenScape Contact Center V8, OpenScape Voice V9
 
Wouldn't touch the settings unless there is an issue.
Would take advise from the maintainer of the other system as what settings they want on the 4K.
Have had to change one once when using an Analogue (POTS) Card (NOT TMANI) to connect to a paging system. Otherwise, the lines when into DEFIL when the paging request ended.
Would need to find what was changed.

 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top