Protocol Rules won't apply to specific users and groups

[ToyodaTim]

Hello-

Ok, I am having a problem and it is quite frustrating because I have no idea why this problem is happening. I am trying to open up port 110 for POP mail access, but I only want to allow administrators to access it. To do this, I created a new protocol rule and set it to allow access to POP3 (TCP Port 110) and in the "Applies To" section, I set it up to only apply this rule to members of the Domain Admins group on our network. When I have it set to apply to specific groups or even specific users, I cannot access POP servers through the network. However, if I set the rule to apply to any request, it works fine. Why is this happening? Shouldn't the rule apply to specific users if I tell it to?

Any help would be greatly appreciated.

-Tim N.
MCP

 

[SgtB]

It should...
Are there any rules that are conflicting with this one perhaps? Although that's a long shot. Since this is one of those issues where it should be working, you might want to consult

http://www.isaserver.org

its got a great forum, and some real pros with ISA.
Sorry I couldn't be of more help. ________________________________________
Check out

http://www.security-forums.com