Programming SIP device on CS1000M

[WarbleKing]

Hello all, I am trying to program an MP118 analog VoIP gateway using SIP trunks and I am having a little dificulty finding some documentation. We have a CSE1000M Rls 4.5 with two sig servers and two media cards for IP phones. I am new to the NRS and the docs tell me I need to go to IP peer Networking: Installation and Configuration (553-3001-213), but I cannot find it on Nortels site. (found-212 and -214)Any help would be greatly appriciated.

 

[PhoneGuyy]

Did you ever get this figured out and programmed?

 

[WarbleKing]

Yes, however the Audio code seemed to be a peice of c&@%!!! It took me about a month to get two way speech. It was working and then it just stopped working after about 3 weeks. When I would call from the CSE1000 to the Audio code it woould work ok, but going the other way I could only get a one way speachpath. Then the support for AudioCode is horrible. We are looking at getting a quintum box that does the same thing.

 

[PhoneGuyy]

Yes so what did you have to program in the CS1000? do you have any printouts or anything you could share