Programming Page and Busy Indicator buttons 1

[ttrevino]

I'm trying to accomplish several things on a Partner ACS 3.0, and I was hoping someone could help me figure out how to do them. I've listed them below, and help would really be appreciated.
1. Program a busy indicator on several phones for x10. (This would show when x10 is on a call.)

2. Program a Page button on an extension? I was told the person's page button didn't work anymore, but I couldn't find anything in the manual talking about this feature?

3. Is there a way to share a mailbox with 2 extensions?

Thanks for helping someone new to this system, TT

 

[telprog]

Question 1 and 2 are the same program.
At any phone.
Feature 00 press a button with lights then press Left Intercom * and the station number that you want to have as a DSS/BLF on that button.It will then show when the phone is being used and you will be able to press it to intercom that set when it is not in use.
As for the VMS question , what voice mail do you have? If it's a VS the answer is no.

 

[ttrevino]

I've give that a try, thanks. What does DSS stand for?
It is a VS system, so I guess it's not possible. There are 2 users that want their extensions to both point to the same mailbox, same password, etc. So if both extensions exist, they both need to have their own mailbox for a message to be left? Thanks for the help, TT

 

[skip555]

What does DSS stand for

Direct Station Selection / Busy Lamp Field

 

[telprog]

guess I should have also told you to use Feature 00 to end programming.

 

[ttrevino]

Ah yes, thanks. I'm used to the G3si or G3R, so programming from a phone is a little bit different. Thanks for the help, I should be able to get them fixed up tonight! )