Programming Mode IPK 1

[jsaad]

I have an IPK with a CPU II 100 U10 card. I am not certain if this is an IPK or an IPK II. There is an InMail flash card on the CPU card.

I cannot get into programming by hitting SPEAKER #*#* or Feature HOLD #0*

Not sure what I am doing wrong, Do I have an IPK or IPK 2? No MIFM but LAN port.

 

[belevedere]

That is an IPK-II. Speaker #,*,#,*, 47544, published in the IPK-II programming manual. It programs up like the 11100/1200/8100/9100.

 

[jsaad]

I do SPEAKER #* and then I immediately get a fast busy. I am on Ext 101, wh/bl, first port on the block.

I guess i need PC Pro but it's different than what you use for SL1100 or 2100?

Customer says the VM doesn't work. Is there an extension for the InMail (3999)?

 

[jsaad]

I have an 8 button phone, I think that is the problem. I need a 16 button?

I can get in via webpro, that worked.

I cannot get the InMail to work. It is a CF Card on a daughter-board on the CPU. Perhaps it has gone bad?

 

[belevedere]

The log in is from ICM dial tone. If your phone is programmed for auto trunk seizure then you will not be able to do SPKR # * # *.
As for the inmail, there is a fair amount of programming to check before trashing the CF chip.
See attached.

 

[jsaad]

I reviewed the programming based on the example. We have nearly everything in there exactly the same as the sheet, our inmail extensions are 150-157 (port 249-256).

Can the card be reformatted? Or is it shot? Is this common?

 

[belevedere]

There is an inmail utility that can be used. If you reformat you will wind up with a CF that can be used in your camera, and no longer be used as a VM.
See attached.

 

[jsaad]

the cf card isn't even recognized by my win xp pc.

I found a copy of inmail utility 2.05 . Would that be able to resurrect it or is it gone?

 

[belevedere]

the cf card isn't even recognized by my win xp pc.
It's probably gone.

 

[jsaad]

thanks. !!