PREDATOR123
MIS
Does any body know the procedure for this
p.s this is to add 30 chnls to an existing route
p.s this is to add 30 chnls to an existing route
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
PROGRAMING QSIG OPTION 81C DUAL PRI
- Thread starter PREDATOR123
- Start date
- Status
Predator,
If you are adding additinal channels to an existing PRI, chances are that you already have the route and last member number. On LD 14, do a change, and on the RTMR prompt, type the existing route number, space, then the next member number. Example, if the route is 10 and the last member was 30, then you input: RTMR 10 31. Once you get good at it, you can add a block on trunks at one time without having to start at the REQ prompt for each new member. Hope this helps.
If you are adding additinal channels to an existing PRI, chances are that you already have the route and last member number. On LD 14, do a change, and on the RTMR prompt, type the existing route number, space, then the next member number. Example, if the route is 10 and the last member was 30, then you input: RTMR 10 31. Once you get good at it, you can add a block on trunks at one time without having to start at the REQ prompt for each new member. Hope this helps.
- Status
Similar threads
- Locked
- Question
- Locked
- Question