Program remotley a Call Pilot 201i 2

[curlycord]

What is required to program/connect remotely to Call Pilot 201i ?

I would presume dialup networking or vpn for starters, what is the programming interface? and would there be an IP needed to connect?.

=----(((((((((()----=
curlycord

http://www.curlycord.com

 

[PERRYPJ]

Dial-Up Networking using PCANYWHERE and the IP of Call Pilot

OLD ROLMEN WORKING ON NORTELS AND AVAYA

 

[telebub]

Or Remote Desktop as a console. On your dial-up networking PC after connecting to the modem, Go to Start/Run and use the mstsc /console from XP Service Pack 2 or mstsc /admin command from Service Pack 3.

 

[curlycord]

So your saying there is no interface to use once connected? its all done via Hyeprterminal or alike???
Where would enter an IP then?


=----(((((((((()----=
curlycord

http://www.curlycord.com

 

[PERRYPJ]

It's all done through WEB BROWSER, you just open it and enter the IP at the top HTTP

OLD ROLMEN WORKING ON NORTELS AND AVAYA

 

[curlycord]

Ahh same as 100/150

thanks!


=----(((((((((()----=
curlycord

http://www.curlycord.com

 

[PERRYPJ]

Yup, the first Versions 1.5 and 1.7 had a Client CD that you loaded on your PC

OLD ROLMEN WORKING ON NORTELS AND AVAYA

 

[telebub]

In addition to what PERRYPJ said, enter it as

http://<ip

address>/cpmgr.