If there's a better forum for Procomm Plus nonscripting questions, perhaps someone could tell me.
I've written my script; now I'm trying to run Procomm from the command line with the option to dial one of the entries in the connect directory, an entry named Cigna. This entry causes the number to be dialed, then launches a script. It works fine when invoked manually from within Procomm. But for the life of me I cannot get the same thing to happen from the command line. Procomm loads just fine, but then nothing happens after that; Cigna is not dialed; the script is not launched.
Also, when I start Procomm from a desktop icon, I get the following error message: "TAPI operation failed for unknown reasons". That will probably stop any successful command line launch when I finally get the command line syntax right. What to do about this? Dispite this message, Procomm works fine when launched manually and this message is cleared.
Many thanks.
I've written my script; now I'm trying to run Procomm from the command line with the option to dial one of the entries in the connect directory, an entry named Cigna. This entry causes the number to be dialed, then launches a script. It works fine when invoked manually from within Procomm. But for the life of me I cannot get the same thing to happen from the command line. Procomm loads just fine, but then nothing happens after that; Cigna is not dialed; the script is not launched.
Also, when I start Procomm from a desktop icon, I get the following error message: "TAPI operation failed for unknown reasons". That will probably stop any successful command line launch when I finally get the command line syntax right. What to do about this? Dispite this message, Procomm works fine when launched manually and this message is cleared.
Many thanks.
