Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TouchToneTommy on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Procomm - Aspect replacement

Status
Not open for further replies.

daytona1

Programmer
Mar 29, 2007
3
US
We log on to a couple of sources to download data using Aspect & Procomm...
We need to use a script, as we have several downloads to do at different "Dealers". VT220 is one of the requirements. I have been looking for a replacement terminal emultion software package to replace Procomm & Aspect. I have looked at the following:
We have to use "Dial-up" for several of these clients. Any help???
 
Just to clarify in case you were needing this, I am not aware of any applications that will run your existing ASPECT scripts (don't know if that was a requirement or not). At one time, Hummingbird offered an ASPECT conversion service for their emulation software, the name of which escapes my mind.

 
WRQ Reflections??

Not sure how spendy it is, but it uses VBA for scripting... pretty nice stuff...

ADP uses it heavily
 
Emtec's ZOC program scripting is pretty close to Procomm. I have several sites with dialup on Nortel PBX and I still prefer Procomm on them, but I use ZOC at locations where our switches are on the LAN, because ZOC supports Rlogin protocol.

Its a good tool too, but I have to say Aspect scripting is a bit easier.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top