Problems with conversion to Access 2002

[PowerfulStar]

Greetings,

I have an Access application that appeared OK when developed in Access 97 on Window 95, but after it was converted to Access 2002 on Window 2000, controls, etc. on forms get a bit bigger and to see everything requires changing the settings to 1024 x 768 resolution.

Any ideas why this is so or a solution to the problem (other than re-designing the forms)?

Thanks and regards,


PowerfulStar

 

[Guest_imported]

Hi,
I don't know if I am right but it is possible that in Windows 95 also you might have been using the 1024 x 768 resolution. So when you installed Windows 2000, the display setting may have been different. Now that you have changed it to a different setting things are ok. So I don't think you need to redesign your forms.
If you use the same sized monitor, then using this resolution should be sufficient.