Problems with autoscaling in bar-charts

[dpbronx]

Hello dear forum; -)

I have problems with the Scalierung in bar-charts.
I must use the autoscaling and the automatic range for bar-charts (diagram assistant).
If start my report, and get by the data base and my choice only zero values back, the diagram indicates a range of values

from -600% to +600%.
Is there the possibility the diagram to provide with default values(e.g. 0%-100%) without the Autoscalierung to lose?

Can anyone help?

 

[Dan3D]

You might try setting a user-defined line on the chart with a value = 0.95.

If you go to FormatChart->Grids and then select "DataAxis" tab and "grids" tab you will see that you can now select "Draw Custom Line". check this box and set your value.

You may also want to select this line and set it to 'transparent' so it doesn't actually show up on the chart. Do FormatChart->SelectedItem and set color to "transparent".

Regards,

-Dan @ 3D (the folks who make the charting library in CR.

Dan Weingart
OEM Technical Manager
Three D Graphics, Inc.

http://www.threedgraphics.com

 

[dpbronx]

Hello Dan,

thanks for your suggestion. I will do it in such a way.
There is probably no better suggestion, because in the following one the bar chart is limited to this range.
For the range from e.g. 0 to 50% I lose now the automatic range.
My diagram represents only very low percentages, I will set the Line to 15%.
Thank you....
With kind regards

Daniel