I am having the following problem backing up in Netware 5.1, can any one help?
I have tried to submit a job using SBcon. I have tried using this but the jobs I submit fail once they are put in the job queue and get to the time they are set to run. I have also conferred with my Netware 5 Administrators Handbook to make sure I am putting the correct information in, which according to the handbook I am.
Because the above failed I decided to put ARCserceIT 6.6 for Netware on the Server. This installed ok, but when I tried to start it on the Server it said that there were no media devices attached and shut its self down. I have reinstalled this twice and have printed and followed the instructions, but the device fails. am wondering weather the tap drive is installed, but I have run Scan For New Device but this didn't find any and I have had the cover of and the device is connected ok. The Server is a Compaq and the DAT drive is the only device on a SymBios SCSI adapter.
I have been told that the Compaq BIOS tries to automatically assign everything to NT11 (IRQ).
Any help with the above would be appreciated.
I have tried to submit a job using SBcon. I have tried using this but the jobs I submit fail once they are put in the job queue and get to the time they are set to run. I have also conferred with my Netware 5 Administrators Handbook to make sure I am putting the correct information in, which according to the handbook I am.
Because the above failed I decided to put ARCserceIT 6.6 for Netware on the Server. This installed ok, but when I tried to start it on the Server it said that there were no media devices attached and shut its self down. I have reinstalled this twice and have printed and followed the instructions, but the device fails. am wondering weather the tap drive is installed, but I have run Scan For New Device but this didn't find any and I have had the cover of and the device is connected ok. The Server is a Compaq and the DAT drive is the only device on a SymBios SCSI adapter.
I have been told that the Compaq BIOS tries to automatically assign everything to NT11 (IRQ).
Any help with the above would be appreciated.