I have an ActiveX Control that was developed (and tested) using Borland CBuilder 5 and now I'm trying to use it in a Access97 form.
When I install this component in a Win98 environment, it works fine.
But, when I try to include it in a WinNT 4 (with service pack 6)environment...
During the design of the form, I insert the control and I can see and manipulate the object (change attributes); but at run time, it appears a message like "Control has no object" and the component appears blank in the form. After that, if I try to go back to the form structure, the message appears again, and the component remains blank in the form, loosing all his properties.
I also tried to include this control in a Oracle Forms6i form, and it seems to have the same behaviour. During the design it's OK, but at run time, the component appears blank.
Could you help me?
Thanks
When I install this component in a Win98 environment, it works fine.
But, when I try to include it in a WinNT 4 (with service pack 6)environment...
During the design of the form, I insert the control and I can see and manipulate the object (change attributes); but at run time, it appears a message like "Control has no object" and the component appears blank in the form. After that, if I try to go back to the form structure, the message appears again, and the component remains blank in the form, loosing all his properties.
I also tried to include this control in a Oracle Forms6i form, and it seems to have the same behaviour. During the design it's OK, but at run time, the component appears blank.
Could you help me?
Thanks