On Sco 5.0.5 I am attemting to build a system from scratch. I am encountering problems when attempting to configure the network card. I have loaded the drivers as per destructions that came with the network card. Gone into Netconfig utility and "add LAN adaptor" I have picked up the correct installed driver and selected the "set speed and duplex mode" as AUTO. After this point the following message is displayed: "unable to load Protocol stacks" any suggestions?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations SkipVought on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Problems detecting network card.
- Thread starter andycox
- Start date
stanhubble
MIS
check that you have SCO openserver "Enterprise" version and not SCO Openserver "Host".
The difference is that Host does not support networking.
The difference is that Host does not support networking.
- Status
Similar threads
- Locked
- Question