KingofSketch
Technical User
I'm currently using Cisco VPN Dialler 3.5 to connect to our Mixed mode domain, i'm not using anything fancy just a standard dial up modem to an ISP connection.
I'm getting in with no problems at all and am able to access emails/ network drives etc, except i am unable to access any network drives on any of our NT4 servers
I am connecting using IPsec over UDP but when i try and map the drives (either by name or ip address) it comes saying that the network path cannot be found
Any ideas would be most welcome
Cheers
Sketch![[lightsaber]](/data/assets/smilies/lightsaber.gif "[lightsaber] [lightsaber]")
"Eagles may soar, but weasels don't get sucked into jet engines"
I'm getting in with no problems at all and am able to access emails/ network drives etc, except i am unable to access any network drives on any of our NT4 servers
I am connecting using IPsec over UDP but when i try and map the drives (either by name or ip address) it comes saying that the network path cannot be found
Any ideas would be most welcome
Cheers
Sketch
"Eagles may soar, but weasels don't get sucked into jet engines"