Hello,
I have Arcserve 6.61 Workgroup installed and have recently purchased Arcserve 2000. When I try to install 2000 it just stops and quits instelf after I have agreed the license conditions.
I therefore think I should just uninstall 6.61 and the install 2000 normally. But I dont want to loose the tape information incase I need to restore something.
Would it be OK if I do the above and after, merge all the tapes into the database, this in theory would rec-create the contents of the database etc.
Does anybody have any suggestions or comments on this problem.
Regards
Phil
I have Arcserve 6.61 Workgroup installed and have recently purchased Arcserve 2000. When I try to install 2000 it just stops and quits instelf after I have agreed the license conditions.
I therefore think I should just uninstall 6.61 and the install 2000 normally. But I dont want to loose the tape information incase I need to restore something.
Would it be OK if I do the above and after, merge all the tapes into the database, this in theory would rec-create the contents of the database etc.
Does anybody have any suggestions or comments on this problem.
Regards
Phil