Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations biv343 on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Problem with running FoxPro 2.6 for DOS in NT on a > 500 MHZ PC
- Thread starter SylviaE
- Start date
1. Upgrade to FoxPro 2.6a if you have not done so already.
Many of these type of problems are relatively very very few and far apart nowadays.
2. DO a scandisk/defrag in your system.
3. If you have set in the BIOS, best performance setting, reset it to OPTIMUM performance setting. Sometimes, the hardware is the reason for such errors.
4. If the PC is faster, some times, any SYS(3) functions throw errors by generating not unique numbers. The solution for this is available and if specifically asked.. I will post the answer for this.
Hope you get the solution.
ramani :-9
(Subramanian.G)
FoxAcc
ramani_g@yahoo.com
Many of these type of problems are relatively very very few and far apart nowadays.
2. DO a scandisk/defrag in your system.
3. If you have set in the BIOS, best performance setting, reset it to OPTIMUM performance setting. Sometimes, the hardware is the reason for such errors.
4. If the PC is faster, some times, any SYS(3) functions throw errors by generating not unique numbers. The solution for this is available and if specifically asked.. I will post the answer for this.
Hope you get the solution.
ramani :-9(Subramanian.G)
FoxAcc
ramani_g@yahoo.com
- Status
