Problem with routing/destination code

[adamandamy]

I know I'm missing something basic but it's driving me to drink. I have 2 BCM 400 4.0s networked with SIP trunks.

BCM1 DN 2XXX and the other BCM2 DN 3XXX everything works fine.
I'm in the process of changing the DN plan in BCM2 to 4XXX to match digits on a new PRI that's being installed.
So I've added 4 as a destination code on BCM1 using the same route as destination code 3 but I get fast busy when I try to dial a 4XXX DN from BCM1 to BCM2.
BCM monitor shows the call grabbing one of the SIP trunks on BCM1 but it never makes it to the other side and 3XXX still works fine.
What am I missing?

TIA

 

[godslavesmith]

try in the target lines

private received

or public received depends on what you did ....

 

[adamandamy]

found the resolution from a different thread. I forgot to look at the routing table in the IP trunk parameters within the telephony resources.