I have added HP Smart Array 641 RAID controller
to my system and tried to install Solaris 9.
In device configuration assistent during installation
I have added drivers obtained from HP (this
device is on HCL for Solaris 9 x86). After copying
neccessary files to disk from CDROM the
installation continued by rebooting the system
from hard disk and after choosing the device
from which to load the kernel, system reboots again,
and it should load the kernel and
continue in installation. When I install the same
OS on same ssystem but with Mylex RAID controller
everything goes OK. Can someone give me advise?
Thanks a lot,
S.
to my system and tried to install Solaris 9.
In device configuration assistent during installation
I have added drivers obtained from HP (this
device is on HCL for Solaris 9 x86). After copying
neccessary files to disk from CDROM the
installation continued by rebooting the system
from hard disk and after choosing the device
from which to load the kernel, system reboots again,
and it should load the kernel and
continue in installation. When I install the same
OS on same ssystem but with Mylex RAID controller
everything goes OK. Can someone give me advise?
Thanks a lot,
S.