Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Problem with Gigabit Trunk / STP Loop

Status
Not open for further replies.
ypswes

ypswes

Technical User
Apr 12, 2002
13
DE

Hey ...

during the Installation of two CAT 5500 with a Gigabit Trunk the following errors ( and a nice Loop ) occurred:

%MLS-4-MOVEOVERFLOW:Too many moves, stop MLS for 5 sec(40000000)

%SPANTREE-2-RX_1QPVIDERR: Rcved pvid_inc BPDU on 1Q port ..

%SPANTREE-2-RX_BLKPORTPVID: Block ... on rcving vlan.. for inc peer...

This Connection worked with 100 FX without any Problems, but when I try to replace this by a Gigabit Connection, I get this " too many moves " and so on... messages.

Is it possible, that I have to configure UDLD Protocol ???
This is just an Idea, but I would be thankful for every helpful device.


best regards
ypswes
 
Status
Not open for further replies.

Similar threads

DavidSigma
  • Locked
  • Question
CP7861 problem
Replies
0
Views
106
DavidSigma
DavidSigma
telepath
  • Locked
  • Question
Unexpected STP Topology Changes
Replies
0
Views
84
telepath
telepath
WinstonCH
  • Locked
  • Helpful tip
What is wrong with the diagram, there are people who will help to fix it? How do i do the configurat 1
Replies
1
Views
172
BIS
BIS
khashyar2021
  • Locked
  • Question
Problem with cisco switch after upgrading
Replies
1
Views
125
Geraldine Souza
Geraldine Souza
inlsp05
  • Locked
  • Question
2811 ios start with cf
Replies
0
Views
86
inlsp05
inlsp05

Part and Inventory Search

Sponsor

Back
Top