Hi everyone, i need your help with a problem
i have a switch router 3com corebuilder 3500 with software 3.0, my problem is when i configure rip, it works but the router declares itself the default gateway of the hole network (backbone), when i have other router (cisco 2501) which is the default gateway in my network(same backbone), but i don't know why some servers or router get the corebuilder as default router, i don't, know what's wrong in the corebuilder rip configuration!!
Index RIP-1 RIP-2 Compatibility Route Cost Poison
Advertisement
Mode Mode Mode Aggregate Reverse Addresses
backbone enabled off disabled disabled 1 disabled
255.255.255.255
subnet enabled off disabled disabled 1 disabled
255.255.255.255
any help would be appreciated!!
thanks in advance!!
Juan Pablo
i have a switch router 3com corebuilder 3500 with software 3.0, my problem is when i configure rip, it works but the router declares itself the default gateway of the hole network (backbone), when i have other router (cisco 2501) which is the default gateway in my network(same backbone), but i don't know why some servers or router get the corebuilder as default router, i don't, know what's wrong in the corebuilder rip configuration!!
Index RIP-1 RIP-2 Compatibility Route Cost Poison
Advertisement
Mode Mode Mode Aggregate Reverse Addresses
backbone enabled off disabled disabled 1 disabled
255.255.255.255
subnet enabled off disabled disabled 1 disabled
255.255.255.255
any help would be appreciated!!
thanks in advance!!
Juan Pablo