Problem with Compaq Proliant 800 server boot

[Razzinator]

I have a Proliant 800 server and it has a 10 gig SCSI HDD in it and that is what the operating system is installed on. I installed a Maxtor Ultra ATA/100 controller and connected a 300GB HDD to it. Now I cannot get it to boot from the SCSI like it was doing before. It tries to boot from the 300GB and of course says nonsys disk. I dont know how to change this since F1-F12 does nothing and I have gone crazy pressing buttons with no luck. Could someone please help me.

 

[mstarrett]

Server Setup has the second scsi set as the primary. Use the server Assistant disk to reload the system.

Warning you will loose all data.

Capt Mike