Problem with CLASS modem Card Setup

[kcdean]

Hi,

We are trying to configure and install a XCMC card in our 61C (4.5). We have run into a problem and get error SCH1885 - The number of CLASS Telephone TN's in the system exceeds the maximum number allowed. Currently the system show "0" CLASS.

This is what we have done so far.

Installed XCMC card in IPE slot 4 0 10

In LD 13 program card.
Reg: new
Type: cmod
tn: 4 0 10 0

I have added CNUA and CNAA to the analog set.

We have the required software packages (95, 332, 333).

What step(s) are we missing?

Thank you,

kcdean

 

[GHTROUT]

Sounds pretty clear based on what you wrote: You have no licenses.

~~~
[small] [©] GHTROUT.com [⇔] A Variety of Free Resources for Nortel Meridian/CS1000 System Administrators [/small]

 

[tnphoneman]

You may have all the packages but you also need an ISM for each analog set you want to program will caller id.

Signature===========================================

http://www.greatwhitetechnologies.com

Aastra Authorized Reseller

 

[kcdean]

I am checking on transfer some spare analog licenses over. Hopefully we can do this.

So it takes a analog ISM and an CLASS ISM to allow caller id?

 

[tnphoneman]

No if you have it set for caller id it uses a class license otherwise it uses an analog license.

Signature===========================================

http://www.greatwhitetechnologies.com

Aastra Authorized Reseller