Problem accessing Secure Gateway after installation

[dwessell]

Hi,

I'm attempting to setup the Secure Gateway in the following scenarion..

Server #1 inside domain, running Presentation Server 4.5 and Web Interface.
Server #2 in separate network (Not a part of domain) running IIS and Secure Gateway. Users will be accessing the Secure Gateway via the internet. Server will also be hosting website via IIS.. For testing purposes all traffic is allowed between networks. I will lock down after setting up system.

I have followed the instructions here (

http://support.citrix.com/kb/entry.jspa?entryID=1737)

for allowing both the SG and IIS to function at the same time. However, when I attempt to access the secure gateway using either

https://FQDN/Citrix/MetaFrame

or

https://(ip

that SG listens on)/Citrix/MetaFrame I get a HTTP 404 error.

When I run the diagnostics, everything comes up fine.

I have two IP's setup, both off of one NIC. One IP is set for IIS, and one for SG..

Can anyone point me in the right direction?

Thanks
David

 

[dwessell]

Well.. I seem to have found the answer..

SG listens on

https://FQDN/Citrix/AccessPlatform,

contrary to what the manual states..



At least it's running from there. I have removed the WI from the server running SG, and WI runs on the same server as PS.

However, from the Session Information from the Secure Gateway for MetaFrame Access Suite, no sessions are shown once I'm connected. Which seems a bit strange to me.